2007 Honda Civic Fog Light Harness Installation Instructions
1. Ensure you have the anti-theft code for the radio, then write down the frequencies for the preset buttons.
2. Disconnect the negative cable from the battery.
3. Remove the radiator cover (4 clips).
4. With the assistance of an assistant, take away the front bumper (six clips, two screws and four bolts). Set the front bumper on a blanket.
5. Apply masking tape to the front bumper across the left fog light area.
6. Utilizing a utility knife, and dealing from the front of the bumper, carefully cut out the front bumper in the area shown. Take care to not injury the front bumper. Remove any burrs from the sides of the hole.
7. Repeat steps 5 and 6 to chop the bumper for the appropriate fog light.
8. Utilizing scissors, reduce out the template. The template “L” is the mirror image of the template “R”.
9. Tape the template marked “L” to the within of the front bumper beneath the left fog light opening. Utilizing a pushpin, pierce the bumper by means of the mark within the template.
10. Whereas sporting eye protection, drill a 10 mm hole via the bumper at the marked location. First drill with a 3 mm drill bit and end with a ten mm drill bit.
11. Utilizing the template marked “r”, repeat steps 9 and 10 to mark and drill the suitable aspect of the entrance bumper.
12. Place the left bracket on the left fog light, and install the two stepped screws and one washer screw. Tighten the screws securely.
13. Inside the entrance bumper, slide the left fog light into the cutout you made, and secure it with three self-tapping screws.
14. Repeat steps 12 and thirteen to install the precise fog light.
15. Route the fog light harness alongside the inside of the front bumper, and plug within the 2-pin connectors into the fog lights.
16. Safe the clips attached to the fog light harness to the left and right fog light brackets.
17. Loosely set up five wire ties with clip on the fog light harness.
18. Bring each of the five wire ties with clip into contact with the respective vertical ribs of the entrance bumper as proven, and tighten the five wire ties with clip securely.
19. Slide the clip onto the two-pin connector of fog light harness and safe the connector to the correct bracket.
20. Remove one bolt from the washer reservoir tank and loosen the 2 bolts.
21. Find the 1-pin connector blue-taped to the car harness and remove the blue tape to free the 1-pin connector. Plug the 1-pin connector you just freed into the 1-pin connector from the sub harness.
22. Route the sub harness between the washer reservoir tank and vehicle panel and route it within the route shown.
23. Safe the sub harness floor terminal to the car body utilizing the ground bolt supplied.
24. Secure the 2 clips from the sub harness to the car frame. Secure the sub harness to the vehicle harness using two wire ties.
25. Reinstall the washer reservoir tank.
26. Plug the 2-pin connector from the sub harness into the 2-pin connector of the fog light harness.
27. Reinstall the front bumper.
